cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
195
Views
1
Helpful
3
Replies

Reload Command to Reboot Both Active and Stby Switch on Modular C9606R

bong31
Level 1
Level 1

Hi, 

We are planning to do failover test on our redundant core switches by shutting down 1-pair(active and standby) of core switch and the other pair should take over. Appreciate anyone can share on the step and command/s on how to reboot both the active and standby switch?

#show switch
Switch/Stack Mac Address : <MAC ADDRESS> - Local Mac Address
Mac persistency wait time: Indefinite
H/W Current
Switch# Role Mac Address Priority Version State
-------------------------------------------------------------------------------------
1 Standby <MAC> 1 V02 Ready
*2 Active <MAC> 1 V02 Ready

-----

 

#show redundancy
Redundant System Information :
------------------------------
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none

Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Up

Current Processor Information :
-------------------------------
Active Location = Switch 2
Current Software state = ACTIVE
Image Version = Cisco IOS Software [Amsterdam], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 17.3.4, 

Peer Processor Information :
----------------------------
Standby Location = Switch 1
Current Software state = STANDBY HOT

 

1 Accepted Solution

Accepted Solutions

3 Replies 3

Hello @bong31 ,

to reload the entire stack, just issue the reload command:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9600/software/release/17-6/command_reference/b_176_9600_cr/high_availability_commands.html#wp1755162844

HTH

Regards, LG
*** Please Rate All Helpful Responses ***

Have confirmed with TAC and reload is the command. Alternative is 'redundancy reload shelf' which will also reload both stacked switch as tested in lab. Thank you.

Leo Laohoo
Hall of Fame
Hall of Fame

@bong31 wrote:
Appreciate anyone can share on the step and command/s on how to reboot both the active and standby switch?
reload