Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We are planning to do failover test on our redundant core switches by shutting down 1-pair(active and standby) of core switch and the other pair should take over. Appreciate anyone can share on the step and command/s on how to reboot both the act...
Hi guys,We have above device with version 17.12.3 that has delay in showing the output of cli command and intermittent when trying to ssh to and from and also intermittent when snmpwalk from remote remote server. Typing cli any commands speed is norm...
We have upgraded a few switches already without issue but we have above issue on two switches lately where the POE Gig ports where the camera is drawing power and data became down and no power is detected even after defaulting the port. When the came...
Did attempted to onboard new Cisco C9120AXI-S but getting Error:Onboarding in place of faulty same model of AP in DNAC. We set the proper discovery parameters but to no avail. Version 2.3.5.5 is running on DNAC. We have factory defaulted the AP befor...
Having issue with eBGPv6 flapping. A few of the similar eBGPv6 sessions having this same issue of constant flapping. Ping is clean and no packet loss. IBGPv4 is stable. BFD key chain is the same on both ends.
Appreciate from you guys who can share th...
Update: We have rebooted but doesn't resolve the issue. After troubleshooting with TAC, he deduced the issue with the routing coz when we try to shut one of the uplink and bring up again try on the other uplink the ssh and snmpwalk is responding norm...
Have confirmed with TAC and reload is the command. Alternative is 'redundancy reload shelf' which will also reload both stacked switch as tested in lab. Thank you.
Yes, stp is running. Did checked the switch configuration related to stp seems no anomaly. Compared the stp status on other working switch no difference also. What puzzles me is that why it affects only management plane.
Thanks Flavio for the response. No abnormalities observed though in cpu and memory when tac checked. We even compared to other working switches in production and no difference. From logs, same no clue also.
