Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1984
Views
0
Helpful
2
Replies

vstack command

schneurfeldman6968
Level 1
Level 1

‎07-01-2020 12:02 PM

Hi everyone,

 

I am currently doing a large network refresh for a client. I am swapping out the current 3750X for a brand new 9300 with a Network Advantage licence.

 

I see in the 3750's config the "vstack" command. Does anyone know what that is? Should I put it on the 9300?

 

Also, anyone have any advice on moving these configs over.

Labels:
0 Helpful
2 Replies 2

balaji.bandi
Hall of Fame
Hall of Fame

‎07-01-2020 01:04 PM

how are you installing these new switches? if you are not looking smart install - then ignore vstack.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

0 Helpful

Leo Laohoo
Hall of Fame
Hall of Fame

‎07-01-2020 04:24 PM

@schneurfeldman6968 wrote:

Does anyone know what that is? 

Read this:  How to use Zero-Touch SmartInstall

Catalyst 9k no longer supports Smart Install (uses a different method) but older models running on classic IOS still support it in older firmware.

If no one is using Smart Install it should be disabled:  Cisco IOS and IOS XE Software Smart Install Denial of Service Vulnerability

 

0 Helpful
Customers Also Viewed These Support Documents