cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
877
Views
0
Helpful
17
Replies

I tried to recover Access-Point ROMMON, But not working tftp32

Faizi
Level 1
Level 1

Hello dear

I have tried to recover AP ROMMON using this method, but unfortunately, it did not work. I would appreciate your guidance and assistance.

Note: I used tftp32 unfortunately the same problem

17 Replies 17


@Faizi wrote:
After that, when I enter the IP in the URL or attempt to open it in a web browser, I encounter an error message (page is unreachable).

Is that HTTP or HTTPS?

It doesn't work in both

One person said that they will no longer use the GUI in the updated versions, everything will be done through the CLI

I need your guide: I have configured or set both 2.4 and 5GHz in one SSID by CLI they do not work like the below line.

ap(config)#interface dot11Radio 0
ap(config)#interface dot11Radio 1
ap(config-if)#encryption mode ciphers aes-ccm
ap(config-if)#ssid HOSPITAL
ap(config-if)#channel least-congested
ap(config-if)#no sh
ap(config-if)#exit
ap(config)#exit

 

Faizi
Level 1
Level 1

Hi Leo Laohoo

"I didn't know your mean. Could you please explain the guide to me? It will be helpful for me."