IPSLA operation type icmp echo is not working on xrv9000

[Mohammed_eliraqy]

I'm facing a problem when trying to configure IPSLA on cisco xrv9000 deployed on openstack lab environment, i get the below error message:

% Failed to commit one or more configuration items during a pseudo-atomic operation. All changes made have been reverted.
!! SEMANTIC ERRORS: This configuration was rejected by
!! the system due to semantic errors. The individual
!! errors with each failed configuration command can be
!! found below.

ipsla
operation 2
type icmp echo
!!% 'ipsla' detected the 'resource not available' condition 'Not supported'

it seems that the configuration is not supported, i use release 6.2.3 and according to to the release notes , IPSLA feature should be supported.

so any clue ?

[majid.jaffari1]

Hello,

Please post the configuration.

best regards,

[Mohammed_eliraqy]

Below is the configuration applied:

ipsla
operation 2
type icmp echo

[majid.jaffari1]

The goal of your configuration is not clear here.

Here is an example that might helps you.

configure terminal

ip sla 10

icmp-echo x.x.x.x source-interface XXX

timeoute 5000

frequency 10

threshold 500

ip sla schedule 10 start-time now life forever

exit

wr

best regards,

[Mohammed_eliraqy]

@majid.jaffari1 i think you didn't notice that i'm talking about xrv9000 configuration , which is using IOS-XR version 6.3.2 , above configuration can be applied to IOS or IOS-XE only.

[majid.jaffari1]

@@@Mohammed_eliraqy

HI,

sorry that I have sent you the standard configuration.

Please try this,

R1(config)#ipsla
R1(config-ipsla)#operation 1
R1(config-ipsla-op)#type icmp echo
R1(config-ipsla-icmp-echo)#source address x.x.x.x
R1(config-ipsla-icmp-echo)#destination address x.x.x.
R1(config-ipsla-icmp-echo)#frequency 60

R1(config-ipsla-icmp-echo)#exit
R1(config-ipsla-op)#exit
R1(config-ipsla)#schedule operation 1
R1(config-ipsla-sched)#start-time now

R1(config-ipsla-sched)#life forever

Before applying this please verify if you havethe following packdges described in this link;

https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-3/general/release/notes/b-release-notes-asr9k-r632.html

Best Regards,

If it helps please rate it.

[Mohammed_eliraqy]

@majid.jaffari1

i'm using xrv9k image, it is a cloud image instantiated over openstack environment.

i have only one package installed as below:

RP/0/RP0/CPU0:R1-xrvr9k#show install active summary
Mon Jan 14 20:46:23.764 UTC
Active Packages: 1
xrv9k-xr-6.5.1 version=6.5.1 [Boot image]

i changed the version to 6.5.1 to check but still stuck with the same error when i try to configure ipsla echo operation 

ipsla
operation 1
type icmp echo
!!% 'ipsla' detected the 'resource not available' condition 'Not supported'

[Nagendra Kumar Nainar]

Hi,

I think XRv does not support IPSLA. Can you try the same config in a physical node?.

Thansk,

Nagendra