Prime Infrastructure, config template device prompts

[paul-d]

Hi,

I'm looking at using Prime 10 via config template to automate the reset of our NAM module as it has a tendency to fail periodically. 

do far I have " do hw-module module 3 reset" however when router then asks for confirmation and I'm not sure how I give it this via a template. 

## I have gone into conf t as this is what prime would do in the below example, as you can see if asks for confirmation, how do I do confirmation using prime, please

WMBC-Civic-6509E#conf t
Enter configuration commands, one per line. End with CNTL/Z.
WMBC-Civic-6509E(config)#do hw-module mod 3 reset
Proceed with reload of module?[confirm]
% reset issued for module 1/3
WMBC-Civic-6509E(config)#

[Flavio Miranda]

Hi

 You can Interactive commands. Take a look here

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-10/user/guide/ciscoprimeinfrastructure_3_10_userguide/create_templates_to_automate_device_configuration_changes.html#con_1107063