Private vlan question

[rolebgoleb]

Ironically never implemented nor really went in depth with them, but say I have a dmz, amd I want to carry that network to my virtual cluster using one cable on multiple hosts.

Is it just an isolated config? All I need is the vlan tag right? Also if it overlaps on my primary network ( the vlan) what happens then?

Essentially I want to use a top row set of ports to decrease the amount of cable runs. From the dmz to the cab.

[Enes Simnica]

@rolebgoleb u good G... To extend your DMZ to multiple hosts via one cable: Use a unique VLAN tag on a trunk port. If the VLAN overlaps with your primary network, traffic will mix (bad). Configure the switch port as a trunk and tag the DMZ VLAN on your virtual hosts. Top-row ports work fine for this. Keep VLAN IDs distinct. If u need the commands and some good links to check out, just ping me......!

-Enes

[MHM Cisco World]

You want to pass DMZ traffic through multi SW

You need to add vlan tag of DMZ in each trunk between SW.

MHM