10-09-2023 03:04 AM
Hi,
I have Cisco C2960 with the following configuration and It won't allow me to configure Radius authentication as there is no commands seems to be avalable. But I have another C2960 and It allows me to configure radius and the only difference is that the software version is 15.0(2)SE6.
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 26 WS-C2960+24TC-S 15.0(2)SE8 C2960-LANLITEK9-M
Expecting some help on this. Thanks
10-09-2023 03:19 AM
Hello @chamaralakmal
Jump to 15.0(2)SE8
See Table 7:
10-09-2023 03:23 AM
what commands are not working, can you post your same ple configuration ?
10-10-2023 02:56 AM - edited 10-10-2023 02:58 AM
Know..both switch ios versions....in which ios version switch radius is working...upgrade the other switch to the same version if possible...
Before upgradation...take current ios as backup....take switch configurations(ram and nvram) as backup including vlan.dat file from flash...then go for upgradation....
Also let us know at which command..you are getting error message....provide more information...so the you will get some clarification...whether issue is related to ios version or not....?
Best regards
******* If This Helps, Please Rate *******
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide