Removing stack configuration

[CrabtreeTech]

The switch was part of a stack at one time, and now is not. When doing a show config the ports for the old switch are shown. 

A show switch command gives show the Switch as 1 Active Priority 15. I have reset the switch but it doesn't clear the stack settings.

I want the switch to operate like it was never part of a stack, and remove the extra ports that are not there. How do I clear all stack settings.

Switch is a Cisco C9300-24U

[Seb Rupik]

Hi there,

Sounds like the second switch is still provisioned if the config is still present. Try the following command:

no switch 2 provision

cheers,

Seb.

[balaji.bandi]

show config the ports for the old switch are shown. 

can you show us example to understand correctly ?

[Leo Laohoo]

---

@CrabtreeTech wrote:

I want the switch to operate like it was never part of a stack, and remove the extra ports that are not there. How do I clear all stack settings.

---

In enable mode, enter the following command:  no switch <NUMBER> provision