SG300-10 Firmware Upgrade Failed

[JoseNog]

Hi Folks,

Today I decided to upgrade my switch from version 1.4.8.06 to 1.4.9.4.

After downloaded to switch and selected the last version, I reboot it (as instructions on manual) BUT never woke up again.

Anyone had this issue too?

Can someone give an hint,please?

Thanks.

Best regards,

Jose Nogueira

[balaji.bandi]

what proceedure you followed ? from GUI or console.

what is the logs you see when you connect to console ? can you post thise logs to suggest.

[JoseNog]

Hello,

The upgrade was with GUI (HTTP).
I can't now to connect to the console because I don't have the serial
cable. I'm going to buy a new one to get the logs.

Thanks,
Jose

[balaji.bandi]

That is the only way you can view logs, that will tell us what is went wrong on the upgrade.

let us know when you have logs.

[JoseNog]

SOLVED!

With the console connection it was possible to access and review all booting process.

My mistake was due to only to try via HTTP. After the upgrade/rebooting the "System Status Led" remained flashing not allowing the HTTP access. 

Now it's working fine.

Thanks a lot for your fast response and avalability!

[balaji.bandi · Accepted solution]

if issue resolved can you make it as solved, so it will be usefull for others.