MX 67W Router interfaces

[AdmiralA]

I have got MX67w router and wanna add it home lab.

So, I have connected one end to ISP modem and the other end to the "Internet" port and got IP from the DHCP server, all good.

Now, I want to:

1- Assign static IP address to the "internet" port with NAT outside (192.168.2.5)

2- Assign another static IP on interface (port 1) with NAT inside (192.168.100.1) to connect it with catalyst CX3560 switch.

Thank you in advance.

[Karsten Iwen · Accepted solution]

1) You'll find this under "Security & SD-WAN" -> Appliance Status -> Uplink

There you can change the IP from DHCP to Static.

NAT will be automatically done for all outgoing traffic.

2) This is done under "Security & SD-WAN" -> Addressing & VLANs

There you can decide if you want to have multiple VLANs, configure your internal IPs and also set static routes if you have VLANs on the internal switch.