Need to assign static IP on umbrella VA 2.4.4 on ESXi

[Jay Tiwari]

Hi Experts,

I have deployed umbrella VA 2.4.4 on ESXi and powered on VA. Just after power on VA goes behind DHCP to pick IP and cu environment doesn't have DHCP. Thus i need to assign static IP just after deployment on OVA, however, i don't see way to assign static IP during initial configuration.

Please let me know if there is way to configure static IP just after OVA deployment.

Thanks & Regards,

Jay

[Niles Pyelshak]

Jay,

Typically, the VA will only grab an IP address from DHCP if there is one.

However, you can go into the configuration mode and statically set the IP address for your Virtual Appliances.

Here is how:

https://docs.umbrella.com/deployment-umbrella/docs/5-configuring-the-vas

Please rate helpful responses.

Niles

[Jay Tiwari]

thanks Niles, however, this document doesn't say how to change IP address in System setting.

[Jay Tiwari]

thanks Niles, however, this document doesn't say how to change IP address in System setting.

[Niles Pyelshak]

This is the new 2.4.4 that you stated. My apologies. 

Try control+B.

https://support.umbrella.com/hc/en-us/articles/360020755952-Configuration-of-the-Virtual-Appliance-Upcoming-Changes

Please rate helpful post.

/Niles