The output of Simple Network Management Protocol (SNMP) calculates the ratio of total outbound messages, and not inbound and outbound messages. To arrive at an accurate value, compare the output of SNMP with the output of the pegcount log file, and refer to the outbound messages only.
To calculate the ratio of 408/480/INVITEs from the pegcount log file in comparison to SNMP output, perform these steps:
Log into the system where Edge Proxy (EP) resides.
Navigate to the Install_dir/log directory.
Look at the Delta data for outbound messages only. The third column on the left of the log file displays this data.
Message Delta In Initial Delta Out Initial INVITE 1152 1152
Add up the values of Delta Out Initial of 408s and Delta Out Initial of INVITEs.
Divide the total outbound values of 408s by the total outbound values of INVITES to arrive at a ratio.
Compare this value with the output of the SNMP server. The values must be close to each other.
Hi All, Custom Tabs on Jabber for windows don't show anything when I click on them. but the same work just fine in Jabber for iOS.? Here's the code: <Client>
please I have ccx 12.5 where I installed a subscriber by mistake without knowing that I don't have a license for it. Now im getting license compliance issue for "CCX permium warm standby 12.5" even after I removed the subscriber and restarted the publishe...
Good Morning ColleaguesI hope you are doing good and safe. I have configured 2 dial-peers , One for VOIP (SIP trunk to third IP PBX) and another POTS for outbound/incoming calls to & from PSTN. The extensions at the third party IP PBX are 1x...
Hello, we are service provider and have migrated to UC-One SaaS platform. The datasheet talks about pre-integrated apps and for our case I only see a plugin to integrate with outlook, no clue where to find the options to enable the integration. We are par...
Hi Everyone: I am trying to figure out a Consider If Formula for an Agent ID/Peripheral Number associated with a Skill Group. Basically, I am trying to queue to an agent, and if my agent is not available, I want to queue to a skill group this a...