This document covers the procedures for configuring conferencing and transcoding support on Cisco IOS voice gateways. The procedures that you perform depend on the type of voice network module you are using to allocate DSP resources.
Determining DSP Resource Requirements
DSPs reside either directly on a voice network module, such as the NM-HD-2VE, on PVDM2s that are installed in a voice network module, such as the NM-HDV2, or on PVDM2s that are installed directly onto the motherboard, such as on the Cisco 2800 and 3800 series voice gateway routers. You must determine the number of PVDM2s or network modules that are required to support your conferencing and transcoding services and install the modules on your router.
STEPS 1. Determine performance requirements.
2. Determine the number of DSPs that are required.
3. Determine the number of network modules that are supportable.
4. Verify your solution.
5. Install hardware.
In regards to calculating DSP`s, there is already a tool for that
Hi Gurus, I have a few video conferencing system that is working internally (i.e. able to communicate to each other) and to some extent, externally too (towards Zoom and Bluejeans).Somehow or rather, I am unable to connect to Amazon Chime as it...
Hi All, The "system status" in CUCM OS admin page displays different Date (with time) and Time Zone.The Date is in UTC and Time Zone in EST.NTP is configured with NTP and stratum 2.No issue with IP-Phones, they display the correct configured time.&nb...
Hello all, I need to be able to remote manage about 10 routers using dial-up modems. It's kind of an old school way of doing things I know, but unfortunately, the sites are in rural areas, most of which have only one ISP option and bad or no cell ser...
The agent has a Cisco 8851 phone and uses finesse. Calls come into the CSQ and assigned to agent,In Finesse, agent hits direct transfer, enters phone number, and hits transfer.Receives red bar across Finesse with a message that says "Error" and...
Our setup was done by a vendor and worked well. All of the sudden 911 calling stopped working. We get an immediate busy signal. I talked with our telco provider and they tell me they can't replicate it so it must be our equipment. I am looking for trouble...