BAD_PARAMETER invalid cli command on 2960X switch stack

[tyhill2014]

Hello All,

I am working on provisioning a 2960X switch stack. This is a two switch stack. It is running 15.2.4(E6) IOS. When the stack boots up, it contacts the DNA Center as expected; however,  after the stack is fully discovered, the onboarding state errors with an initialization error 'BAD_PARAMETER invalid cli command'. Has anyone else run into this issue with provisioning a switch stack?

Thanks

Ty

[tyhill2014]

Found out yesterday from the TAC engineer that DNAC vers. 1.2 does not support 2960-X stacked switches. These switch stacks are supposed to be supported in DNAC vers 1.4 which should be available in August.