Cisco 3750 + Ansible IOS commands
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-24-2021 04:40 AM - edited 01-24-2021 04:41 AM
Hi,
I have a site using 3750 switches and am trying to integrate these with ansible. However the C3750’s can only run IOS 12.2 due to their amount of flash.
Ansible tries to run the command ‘show run | section ^interfaces’ however the 3750 does not
support the ‘section’ modifier. Is there any IOS versions for the 3750 that support this command or is IOS 15 required?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2022 03:00 AM
Hello everyone,
I have the same error as you, what was the solution?
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2022 03:02 AM
Hello everyone,
I have the same error as you, what was the solution?
Thanks.

- « Previous
-
- 1
- 2
- Next »