Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After confirming MPLS L3VPNs and doing some internet breakout tasks. I wanted to have a look at leaking routes between VRFs away from L3VPNs. I have been able to use a import map within the VRF to import specific routes using a route-map and prefix l...
Hi All, I found a Cisco 2504 wireless lan controller at one of our sites and have powered it up and found that its only licensed for 10 access points (bit of a bummer). When ive gone into the licenses section of the WLC i can see the attached From t...
I have a stack of two WS-C3750X-24T-S switches in a stack that will not update past 15.2(1)E2. I have tried the following versions:c3750e-universalk9-mz.152-4.E.binc3750e-universalk9-mz.152-4.E10.bin I have attached a text file with the console outpu...
Hi, I have a site using 3750 switches and am trying to integrate these with ansible. However the C3750’s can only run IOS 12.2 due to their amount of flash. Ansible tries to run the command ‘show run | section ^interfaces’ however the 3750 does notsu...
Please could someone write an example configuration for QoS policing/shaping for bandwidth control. I am wanting to limit a customers upload speed to 10mbps and download speed to 20mbps. They come into the ISP Core router on fa0/0. All traffic on thi...
From the error "Network error: Connection Timed Out", it sounds like a connectivity issue too. See the results of what @balaji.bandi has asked as you may have a problem with connectivity between your management station and the switch.
Firstly, I would sanitize that config and re-upload it. As this contains your passwords and is publicly viewable on the internet....! The SSH config looks okay. Have you regenerated the RSA keys? I have seen this be an issue in the past. Are you gett...
Thanks Harold,Happy New Year to you too! How would I go about getting this working then? Do I just have to use an import route-map? Or is it better to get the routes into the VPNv4 table and do it that way using the RTs? Not sure what best practice i...
