Prime 3.4 Complaince Job - Fix Inputs

[Jason Mann]

I am having trouble getting the Rules Input variable to work correctly. I have selected Fix for the scope and included the variable in my cli fix screen but when I try to run the fix for the compliance job I just get "Fix Input not available" I have included some screenshots. Anyone ran into this or know how to fix?

[Jochen Reinecke]

Hi Jason,

you can use variables with input if u are using ^ in front and at the end of the variable. Example:

^<_VAR>^

As you can read in the Compliance Guide:

Fix CLI

Note This field is available only if you selected User defined Violation Message in the Violation Message Type field. Enter a relevant CLI fix if the device does not meet the condition specified. Do not enter config t , configure , and its exit commands. Rule inputs and Grep outputs can be used here. Note The exit command is allowed in main and sub-level commands. Following are the formats for the CLI fix that you enter in this field: For an execution type input, enter <Rule input ID> For a fix type input, enter ^<Rule input ID>^ For a grep type output, enter <n.m>, where n is the condition number and m is the output number.

Hope that helps.

Best regards,

Jochen