Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
we have updated a distribution stack of Catalyst 3850 Switches from IOS XE 3.x to IOS XE 16 Fuji. After the successful update we have realised, that Flex Link Support is not included in this Releases. Bad News, because we're searching for a Swi...
Hello Community,
i worked on an issue with slow network speed between a site router (Cisco 886) and a Palo Alto Firewall for several days now. The site is using VDSL (in Germany) with about 50Mbit/s Downlink and 10Mbit/s Uplink. Here is the output f...
Hello guys,
i like to route between some Multilayer-Switches in our Company. Two of them are oparing in an HSRP-Group for some Client-VLANs. So These Switches only have L2-Connections between them, no routed-ports.
I want to connect a third Multila...
If someone is searching for a solution with IOS-XE 16.X-Versions and FlexLinks. The Feature ist just not supported anymore. BTW: It's true. Cisco advise is to use Spanning Tree instead. Best regards,Jochen
Hi Jason, you can use variables with input if u are using ^ in front and at the end of the variable. Example:^<_VAR>^ As you can read in the Compliance Guide: Fix CLINote This field is available only if you selected User defined Violation Message in ...
Hello Georg,
thanks for your hint. I have lowered the tcp adjust-mss on dialer Interface but the Speed stays at Maximum of 355 KB/s. The Internet Access is behind the tunnel as you expected. NAT Rule and ACL is cleared for the posting.
Regards,
Joc...
