Unable to get a response from Cisco Prime Provisioning API

[Mike Hagans]

Hello all,

I'm using Postman to attempt to get a response from Cisco Prime Provisioning, but I'm not having much luck. I'm going along with the below documentation from Cisco, however, it does not clearly state the URL I should use or what type of Auth either. This is what I have done so far. URL = https://ip-address and I've tried using Basic Auth with the globaladmin account. Apparently, Prime is supposed to fail at first, then send you back the session id, but it fails and fails

Any help would be much appreciated! Thanks!

[Mike Hagans]

This time with the doc.

Cisco Prime Provisioning API Programmer Guide, 6.8 - Getting Started [Cisco Prime Provisioning] - Cisco

[Spencer Zier · Accepted solution]

This is not the right community for this question.  This community is specifically for the Prime Infrastructure API.  I think your best bet for this question is the Prime Collaboration Management support forum.