Cannot see nor stop the default example lab topology simulation in CML

[adamle001]

On the rare occasion I am able to make a reservation for CML, once I login, I am unable to see the example lab topology in the dashboard and therefore unable to stop that simulation so that I may run my own. I end up running into the maximum device limit for a topology I've run many times without issue once I stop the example lab topology first. Incredibly frustrating to finally get a reservation and not be able to model what I need to. Any help on how to stop a topology that is running but can't be seen in the dashboard would be greatly appreciated.

[bigevilbeard]

Saw some post this before and they said - you need to wipe the config (or actually the state) to remove a node or a lab. It's documented here: https://developer.cisco.com/docs/modeling-labs/#!deleting-nodes

[adamle001]

Normally I stop, wipe and delete the example lab topology in order to free up resources and spin up my own topology. I can no longer see the default example lab topology and therefore am unable to stop, wipe and delete it. It seems to be running though, given the high resource utilization and my inability to run my own topology due to reaching the node license limit.  

[Martin L]

It has Been problem since the latest update of CML. 

Let me know if your or any solution works 

Regards, ML
**Please Rate All Helpful Responses **

[adamle001]

I've never experienced this issue until just this week where the default topology doesn't show up but appears to be eating up resources. I was fortunate enough to grab a reservation and essentially could do nothing with it : ( I'll keep you posted if I ever arrive at a solution.