02-04-2023 11:03 AM
Trying to set-up a simple topology using nxos9000 nodes and I see only three interfaces when using link connector to connect to other nodes. At one point I had seen more than that but lately I see only three interfaces. I need few more interfaces to create complete topology.
Has anyone else experienced same? Does anyone have a solution?
Thank you,
Naren
Solved! Go to Solution.
02-04-2023 12:20 PM
by default it should offer you 20 interfaces, if you like more you can add as below :
https://developer.cisco.com/docs/modeling-labs/#!adding-interfaces-and-overprovisioning
02-04-2023 11:28 AM
@NarenB whats this in CML, personal, ent, sandbox?
02-04-2023 11:52 AM
CML
02-04-2023 12:46 PM
In the sandbox version?
02-04-2023 02:14 PM - edited 02-04-2023 02:14 PM
@bigevilbeard yes, in sandbox version. At one point there were 20 interface but after that I see only three to create "physical links".
02-05-2023 01:32 AM
Put a ticket into the team, if this was 20 before something then has changed --> HERE
02-04-2023 12:20 PM
by default it should offer you 20 interfaces, if you like more you can add as below :
https://developer.cisco.com/docs/modeling-labs/#!adding-interfaces-and-overprovisioning
02-04-2023 02:15 PM
@balaji.bandi I need only 5 but I see only thee available Eth1/1-3
02-04-2023 02:17 PM
i was not sure on the sandbox, never used that should support it - I was keener to address using the personal edition.
SANDBOX - that may be a limitation not sure.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide