06-22-2020 10:21 AM
I`m not getting to configure QoS in IOSv-L2. Is there QoS by default in this version or I have to enable this feature? How can I do that?
Solved! Go to Solution.
06-22-2020 11:34 PM
QoS not fully implemented in L2 images .. use L3 image for practice.
QoS is normally a hardware-dependent feature on switches .. not all commands and features would work as its virtual environment. L3 image would give you better experience.
06-22-2020 11:34 PM
QoS not fully implemented in L2 images .. use L3 image for practice.
QoS is normally a hardware-dependent feature on switches .. not all commands and features would work as its virtual environment. L3 image would give you better experience.
06-23-2020 08:32 AM
11-12-2021 09:49 AM
Did you try to run the lab on Cisco Packet Tracer 8.0.0.0212? you'll be amazed that you can run a lot of QoS commands there!
Good luck..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide