SD-WAN LAB: Access to console of VM: vManage vedge vBond

[vantruongsinh]

Hi guys,

I am factory reset the setting on the VManage vEdge and vBond.

Is there any way I can get access to console level of the VM to start the configuration ?

Not sure if the sandbox lab support this.

[bigevilbeard]

Hello @vantruongsinh there is no access to the VM's to which the vBond (vManage / vSmart) are built for users. You could try and build your own SD-WAN fabric in the CML sandbox, which might give you the flexibility you are looking for.

Hope this helps

[vantruongsinh]

Thanks @bigevilbeard , I will give it a try and see how it goes

[vantruongsinh]

Hi @bigevilbeard I have tried the CML lab at 

https://devnetsandbox.cisco.com/RM/Diagram/Index/685f774a-a5d6-4df5-a324-3774217d0e6b?diagramType=Topology

 but I dont seem to get any luck to power on the vManage and it stayed in QUEUE state for a while.

I have many nodes but none of those are power on while I tried to power on the vManage

Let me know if I need to open another thread for this question

[bigevilbeard]

Hello @vantruongsinh i am not an expert in CML sadly, i have not seen this is an issue (not with SD-WAN CML) log into the System Administration Cockpit, download the logs and see if there are any errors.

Hope this helps.