Dear All, I have a client that is experiencing several routers that when started remain as shown in the following. This looks like someone wanted to throw out some commands. I solved it by entering ROMMON mode and throwing a new image at it. after time it happens again.
For me it is something external but I could not find it. I pass it to someone?
thank you
If you require further assistance please contact us by sending email to
export@cisco.com.
Installed image archive
Cisco CISCO2921/K9 (revision 1.0) with 479232K/45056K bytes of memory.
Processor board ID FJC2007A042
3 Gigabit Ethernet interfaces
1 terminal line
1 Channelized (E1 or T1)/PRI port
1 Virtual Private Network (VPN) Module
4 Voice FXO interfaces
2 Voice FXS interfaces
DRAM configuration is 64 bits wide with parity enabled.
255K bytes of non-volatile configuration memory.
255488K bytes of ATA System CompactFlash 0 (Read/Write)
no logging discriminator
% Incomplete command.
Logging of %SNMP-3-AUTHFAIL is disabled
logging queue-limit esm 0
^
% Invalid input detected at '^' marker.
ipc holdq threshold upper 0
^
% Invalid input detected at '^' marker.
ipc holdq threshold lower 0
^
% Invalid input detected at '^' marker.
ethernet cfm alarm packet 0
^
% Invalid input detected at '^' marker.
cef table vrf tree IPv6 type RTREE
^
% Invalid input detected at '^' marker.
cef table output-chain build favor default
^
% Invalid input detected at '^' marker.
wrr-queue bandwidth 1 16 64 255 255 255 255 255
^
% Invalid input detected at '^' marker.
ip nbar resources system 30 23744 25
^
% Invalid input detected at '^' marker.
no ip sctp authenticate init
^
% Invalid input detected at '^' marker.
no ip sctp authenticate init-ack
^
% Invalid input detected at '^' marker.
no ip sctp authenticate shutdown-complete
^
% Invalid input detected at '^' marker.
no ip sctp authenticate authentication
^
% Invalid input detected at '^' marker.
ip pgm host join 0
^
% Invalid input detected at '^' marker.
no ip cef accounting
% Incomplete command.
ipv6 nd ns-interval 0
^
% Invalid input detected at '^' marker.
ipv6 nd dad time 0
^
% Invalid input detected at '^' marker.
kerberos timeout 15
^
% Invalid input detected at '^' marker.
multilink virtual-template 0
^
% Invalid input detected at '^' marker.
cts sxp node-id 0
^
% Invalid input detected at '^' marker.
rtp-port range 0 0
^
% Invalid input detected at '^' marker.
%Text Relay needs to be enabled before the options being configuredPort number already in use.Port number already in use.Warning: Configuring media inactivity detection to avoid hung calls is highly recommended.
l2protocol-tunnel global drop-threshold 0
^
% Invalid input detected at '^' marker.
% Policy already has same proposal set
crypto ikev2 nat keepalive 0
^
% Invalid input detected at '^' marker.
crypto ikev2 dpd 0 0 periodic
^
% Invalid input detected at '^' marker.
crypto ikev2 limit max-sa 0
^
% Invalid input detected at '^' marker.
ip tcp mss 0
^
% Invalid input detected at '^' marker.
crypto ipsec security-association dummy
% Incomplete command.
%Warning: Default transform set has been modified.
set security-association dummy
% Incomplete command.
buffers header min-free 128
^
% Invalid input detected at '^' marker.
buffers header initial 0
^
% Invalid input detected at '^' marker.
buffers fastswitching min-free 128
^
% Invalid input detected at '^' marker.
buffers fastswitching initial 0
^
% Invalid input detected at '^' marker.
%GigabitEthernet0/0 is a static pool and cannot be tuned
%GigabitEthernet0/0 is a static pool and cannot be tuned
%GigabitEthernet0/0 is a static pool and cannot be tuned
%GigabitEthernet0/0 is a static pool and cannot be tuned
%GigabitEthernet0/1 is a static pool and cannot be tuned
%GigabitEthernet0/1 is a static pool and cannot be tuned
%GigabitEthernet0/1 is a static pool and cannot be tuned
%GigabitEthernet0/1 is a static pool and cannot be tuned
%GigabitEthernet0/2 is a static pool and cannot be tuned
%GigabitEthernet0/2 is a static pool and cannot be tuned
%GigabitEthernet0/2 is a static pool and cannot be tuned
%GigabitEthernet0/2 is a static pool and cannot be tuned
tx-ring-limit 0
^
% Invalid input detected at '^' marker.
tx-queue-limit 0
^
% Invalid input detected at '^' marker.
dot1q tunneling ethertype 0x8100
^
% Invalid input detected at '^' marker.
ipv6 nd ns-interval 0
