Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, I have a client that is experiencing several routers that when started remain as shown in the following. This looks like someone wanted to throw out some commands. I solved it by entering ROMMON mode and throwing a new image at it. after ti...
Dear, good afternoon. I have an FDT HA model 1010. I have Firmware 6.4.0 and I must update to a new version. The question is should I update each one of the nodes or do I throw the firmware to the secondary and both are updated? Do you have any docum...
I am trying to make an IPSEC between a Cisco Firepower Management Center 1000 FW and a Cisco ASA 5508 but I am not being able to make them see each other. I don't see logs anywhere of IKE attempts on any version. I tried in V1 and V2, with all the po...
I am putting together a script in the contact center, which must make queries to an external base by Make rest Call.I must make a POST to a database so that it brings me a TOCKEN and then when that works, with that token I must validate myself and ma...
I am wanting to see the reports within Umbrella, but when I enter anyExample: Activity search.And the browser stops responding (use both Chrome, Firefox, EDGE) in Windows 11. The client also uses Mac and the same thing happens.Now I tried on a newly ...
Thanks . My last question is, I loaded the 6.4.0.15 image, now 6.0.14 and 6.0.15 appeared, which one do I use? On the other hand, I first install the Fisco Firepower mgmt Center patch, finish that , and then install Cisco FTD SSP FP1k? Thank you
The FDTs are in a Cluster, do I have to apply the update to both? Or do I upload it from the Update tab and when I install it, it already applies it to both nodes of the cluster?
Thanks
I tried to generate traffic but nothing. The strange thing is that on the FP side it never generates IPSEC traffic, is it necessary to activate something within the Interface? I also generated a nat for phase 2 since I saw in a video that they did it...
