simple RIP Config

[DavidArias05]

Hi,

I got a simple project using 4 different networs, I'm trying to comunicate their users using dinamic routing with RIP protocol.

I got this simulation.

I configure the routers:

R0

R1

R0 - RIP

R1-RIP

The protocol route the serial interface, but it doesn't work with the terminal users, i hope that someone could give me an advaice.

I'm using the last version

Thank you

[Kasun Bandara]

@DavidArias05 hi,

as per your captures, you added 20.20.20.0 range to R1 and 172.16.0.0 range in R0. according to diagram those are connected other way. can you try swapping those networks between router r1 and r0. in RIP you need to advertise connected networks.

[DavidArias05]

##- thank you, I did the swap of network, but it doesn't work still -##

[M02@rt37]

Hello @DavidArias05,

Add redistribute connected under each router rip process.

[DavidArias05]

I already  fix the issue, i add their own network on the RIP configuration, and now i can comunicate the terminal user

thaks four your help