10-16-2012 06:08 AM - editado 03-21-2019 04:14 PM
Today I had to reset the router completely to factory default, if I was adding services to the forwarding or UpNp service management, suddenly it stopped adding the new ones.
Even a restore didn't help.
Now after starting all over it's having the same behaviour, see below my services, normaly you can have 30 rules in this list but I cannot add new ones now.
Now I want to insert a new service IMAPS for port 993 so I go to service management
Then press "add to list" see below for result
It is there, then press OK and the screen closes, now if I choose a service from the list, it is not there !!
What is going wrong?
el 10-16-2012 09:56 AM
Ryan, this may be a browser related issue. Try to swap to firefox, chrome, ie, etc.
-Tom
Please rate helpful posts
el 10-16-2012 11:18 AM
Sorry, no luck.
I have installed Mozilla Firefox and it gives me the same issue.
When I add a new rule it overwrites another one and I cannot see that I have already 30 rules now here :
And unused rules in my environment I cannot change or delete so I have more space for new rules.
el 11-21-2012 01:23 PM
How many services can you add in the service management list?
Sent from Cisco Technical Support iPhone App
el 11-21-2012 05:42 PM
Ryan, I can't recreate your problem. I have a RV042G here where I have 30 services and as described, adding more over-writes a service since it is limited to 30. But honestly, I wish the router would just give an error indicating more services can't be added.
-Tom
Please rate helpful posts
el 11-21-2012 11:30 PM
Hi,
But I only have 23 services yet in this service management and it already overwrites the last one.
This very annoying because I want to try out this FTP problem and I cannot add a service anymore.
Also there are a few services in this list which I do not use and I cannot change because these are probably defaults?
Ryan
el 08-21-2013 09:53 AM
Hola, este problema fue resuelto? En estos momentos tengo el mismo problema y no se como solucionarlo. Podrian agregr una respuesta con la solucion?
Gracias
Cristian Betancur
Colombia
el 08-22-2013 06:28 AM
Hola, he podido resolver el problema sin restablecer los valores de fabrica del router RV042. Ingresando desde la red local se presenta el problema de no poder agregar mas servicios a la lista de servicios, pero al ingresar desde una red externa (Internet) pude agregar, editar y eliminar servicios de mi lista de servicios. Espero este problema no sea un bug del Firmware 4.2.2.08 y si lo es, ojala se corrija el problema en una nueva versión de Firmware.
Cristian Betancur
Descubra y salve sus notas favoritas. Vuelva a encontrar las respuestas de los expertos, guías paso a paso, temas recientes y mucho más.
¿Es nuevo por aquí? Empiece con estos tips. Cómo usar la comunidad Guía para nuevos miembros
Navegue y encuentre contenido personalizado de la comunidad