- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-28-2015 11:53 AM
I am trying to run the system upgrade process on C300V. In the system upgrade screen the interface is set to one of the interfaces configured for the system. It is set to the internal interface. With it set this way I cannot run updates or update anti-spam. I have another C300V and its system update interface it set to Auto. How can I change the interface setting for System Updates?
Solved! Go to Solution.
- Labels:
-
Email Security
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-28-2015 01:12 PM
In the GUI:
Click on Security Services/Service Updates
About midway down the page you can select the interface there.
YES, I KNOW that the text says it doesn't apply... but I just tested I on mine running 8.5.6-092, and The page in System Administration/System Upgrade changes to whatever I set it to...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-28-2015 01:12 PM
In the GUI:
Click on Security Services/Service Updates
About midway down the page you can select the interface there.
YES, I KNOW that the text says it doesn't apply... but I just tested I on mine running 8.5.6-092, and The page in System Administration/System Upgrade changes to whatever I set it to...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-28-2015 01:14 PM
That was it. Thank you so much!!!!!

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-02-2015 04:28 PM
You may also use the CLI and use the 'updateconfig' command and follow the prompts (press enter) then when you get to the interface portion you can make the change to the interface there as well.
