05-09-2013 03:51 PM
I may be missing something obvious, but I cannot create an Inbound Mail Policy with and LDAP Group Query. (ASYncOS 7.6.1-022, Active Directory, Exchange 2010). I follow the steps in Chapter 3 of the advanced guide for creating and LDAP group query (1. In the CLI, create a filter with the rcpt-to-group filter rule. I am using the insert-header action. 2. The LDAP server is already configured because we are using it for the accept query. I enabled a group query and I can test the group query with the DN I am interested. 3. The group query is chosen on the listener page.)
When Insert a new Incoming Mail Policy and select group query, I get the error plese define at elast one user for this policy. If I add a recipient address and save it and then open it again, the group query part is blank.
Sorry if I'm missing something obvious.
Steve Moss
Pomona College
05-14-2013 08:24 AM
Hi Steve,
I would suggest to open a case with TAC for a configuration check and test. If you have configured the group query which disappears after saving it is possible that this is unexpected behavior.
Regards,
Enrico
04-30-2014 02:41 PM
Did you get an asnwer for this from TAC?
05-05-2014 01:45 PM
I was able to resolve this, you can close the issue.
Thanks
Steve Moss
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide