Problem Creating LDAP Group Query for Incoming Mail Policy

[slm04747]

I may be missing something obvious, but I cannot create an Inbound Mail Policy with and LDAP Group Query.  (ASYncOS 7.6.1-022, Active Directory, Exchange 2010).  I follow the steps in Chapter 3 of the advanced guide for creating and LDAP group query (1. In the CLI, create a filter with the rcpt-to-group filter rule.  I am using the insert-header action. 2. The LDAP server is already configured because we are using it for the accept query. I enabled a group query and I can test the group query with the DN I am interested. 3. The group query is chosen on the listener page.)

When Insert a new Incoming Mail Policy and select group query, I get the error plese define at elast one user for this policy.  If I add a recipient address and save it and then open it again, the group query part is blank.

Sorry if I'm missing something obvious.

Steve Moss

Pomona College

[Enrico Werner]

Hi Steve,

I would suggest to open a case with TAC for a configuration check and test. If you have configured the group query which disappears after saving it is possible that this is unexpected behavior.

Regards,

Enrico

[Ken Stieers]

Did you get an asnwer for this from TAC?

[slm04747]

I was able to resolve this, you can close the issue.

Thanks

Steve Moss