cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5487
Views
10
Helpful
2
Replies

AMP: Disabling DFC and TETRA on Servers

matty-boy
Beginner
Beginner

Hello all,

 

I'm under the impression that if installing the AMP connector on a Windows server, we should disable DFC and TETRA.

Can anybody point me at an up-to-date document or web page that shows this recommendation?

 

Many thanks in advance,

Matt.

1 Accepted Solution

Accepted Solutions

Matthew Franks
Cisco Employee
Cisco Employee

Matt,

 

The Deployment Strategy Guide used to advise against deploying AMP with DFC and TETRA enabled to servers.  Due to improvements in those over the last few years the verbiage has changed to "WARNING! Running DFC/TETRA on a server without testing and proper Exclusions could significantly impact performance.".  So we don't recommend against it any longer, just recommend that you perform appropriate testing before deploying it widespread in any environment.

 

https://docs.amp.cisco.com/en/A4E/AMP%20for%20Endpoints%20Deployment%20Strategy.pdf

 

Hope that helps!

 

-Matt

View solution in original post

2 Replies 2

Matthew Franks
Cisco Employee
Cisco Employee

Matt,

 

The Deployment Strategy Guide used to advise against deploying AMP with DFC and TETRA enabled to servers.  Due to improvements in those over the last few years the verbiage has changed to "WARNING! Running DFC/TETRA on a server without testing and proper Exclusions could significantly impact performance.".  So we don't recommend against it any longer, just recommend that you perform appropriate testing before deploying it widespread in any environment.

 

https://docs.amp.cisco.com/en/A4E/AMP%20for%20Endpoints%20Deployment%20Strategy.pdf

 

Hope that helps!

 

-Matt

Thank you Matthew! That's great!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers