Secure Endpoint Connector not installing silently

[ITGuy472]

I am trying to install our Secure Endpoint Connector silently and the only documentation I have found recommends the use of /s or /r /s depending on the version, 8.0 in our case.

No matter which command line switch I try to use with amp_Protect.exe it just runs the UI for the installer. Even If I try to use /? or /help I get nothing but the UI.

[Matthew Franks]

Try /R /s instead of /r /s.

Thanks,

Matt

[ITGuy472]

Thanks for the suggestion, but that did not seem to have any effect. It still opens the installer GUI on the "Choose Install Location" page and requires manual input to continue.