10-16-2014 09:46 PM - edited 03-11-2019 09:57 PM
My setup is :PIX 515E, IOS 8.0(4)28, ASDM 6.1(5)57, Firewall mode routed, 6 interfaces, 128Mb.
My question is, can ASDM be accessed through any interface on the PIX besides ethernet1? I'd prefer to run ASDM through ethernet5 but it refuses to run. I have tried deconfiguring eth1 and copying its config to eth5 to no avail. The basic setup on eth1 that works is:
interface Ethernet1
nameif Management
security-level 100
ip address 100.100.100.18 255.255.255.0
This doesn't work on eth5.
Matt.
Solved! Go to Solution.
10-17-2014 03:27 AM
Hi,
Would you be able to reply with these outputs from the PIX:-
1) show asp table socket
2) show run interface eth5
Also , is the IP from which you are trying to access the ASDM in the same Network as the range configured on the Interface ?
Thanks and Regards,
Vibhor Amrodia
10-21-2014 03:03 AM
Hi,
So , were you able to resolve this issue ?
Thanks and Regards,
Vibhor Amrodia
10-17-2014 03:27 AM
Hi,
Would you be able to reply with these outputs from the PIX:-
1) show asp table socket
2) show run interface eth5
Also , is the IP from which you are trying to access the ASDM in the same Network as the range configured on the Interface ?
Thanks and Regards,
Vibhor Amrodia
10-18-2014 08:46 PM
The responses are as follows:
PIX515E# show asp table socket
Protocol Socket Local Address Foreign Address State
TCP 0002082c 100.100.100.18:23 0.0.0.0:* LISTEN
SSL 0002e9ec 100.100.100.18:443 0.0.0.0:* LISTEN
SSL 0008993c 100.100.100.18:443 Miffy:1063 ESTAB
PIX515E# show run interface eth5
!
interface Ethernet5
description MGT_INTERFACE
speed 100
duplex full
nameif Management
security-level 0
ip address 100.100.100.18 255.255.255.0
I figured it out. I was allowing telnet/http access to the inside interface, not the management interface. Inside is Eth1, Management is Eth5.
A force of habit. As this PIX has 6 Eth interfaces I thought I'd dedicate one to management. Now to interface between my 877 & 1751-V!
Thanks for your help Vibhor.
10-21-2014 03:03 AM
Hi,
So , were you able to resolve this issue ?
Thanks and Regards,
Vibhor Amrodia
10-21-2014 12:47 PM
Yes thanks Vibhor. I was reminded of a valuable lesson, it's all in the logic. The answer, as usual, was staring me in the face. ASDM can be accessed from any interface. In the process I also figured out that you can't telnet into these PIX. One must set up SSH2 to do this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide