Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have encountered a strange issue with my 3560G switch running c3560-ipservicesk9-mz.150-2.SE10a.bin. It will ping the gateway and other computers for a short time then refuse to ping anymore. The only way to get ICMP replies is to move the crossove...
I have devised the following ZBPF on my 1941 router. Problem is IPv6 doesn't work. I cannot get any IPv6 connectivity. IPv6 works fine with the ZBPF disabled, i.e. not applied to any interfaces. Anyone have any ideas as to why it doesn't work. !
clas...
I have a 1941 with the security licence. I also bought a 1941W cheaply off eBay. It only had a base licence. I tried swapping the wireless module from the 1941W to the 1941. The 1941 would not recognise it and threw up errors. Both have the latest IO...
Hi all. Fairly new to this game. I understand the router on a stick concept well. I was wondering if there were a way to terminate VLANs via a trunk link to a router without using sub-interfaces on the router. I'm thinking along the lines of using a ...
Thanks Kasun. It turns out that the NetComm internet router was issuing DHCP leases wirelesly that overlapped the IP addresses I was using on the LAN side. A reconfigure to lease only in the 10.1.1.200 -10.1.1.254 block has fixed this. I also dropped...
Thanks for the replies. The IOS is 15(7)3M4. It was a copy/paste error, the below is the corrected version. IPv4 works as intended:!
zone-pair security lan-wan source lan destination wan
service-policy type inspect lan.pmap
! Also, I get this:R1941#...
Here's mine off my 1941. It is still a work in progress: !
class-map type inspect match-any addresses.cmap
match access-group name addresses.ipv4.acl
match access-group name addresses.ipv6.acl
!
class-map type inspect match-any protocols.cmap
matc...
