cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1569
Views
0
Helpful
2
Replies

Need help with IPV6 and multicast...

bakelmion
Beginner
Beginner

Long and short is that I have a switch only network (not because I wanted it, but because I was given it as a cruel joke) there are three networks per switch, and three layer three interfaces. Vlan 400,450 and g1/0/24. Unicast works through. Now I am trying to get unicast to function. There are no ACLs (removed for troubleshooting). My multicast host is on Vlan 400. I am not seeing any traffic from the host past the Vlan. (At the routed port)

Any ideas?

2 Replies 2

Georg Pauwen
VIP Master VIP Master
VIP Master

Hello,

 

what do you have configured on the switches for IPv6 multicast ? And what switch models are these ?

 

Post the running config of one of the switches...

zeno38
Beginner
Beginner

PIM must be enabled on all layer 3 interfaces. You may also need an RP, or rendezvous point, for the multicast source to register with, depending on the version of IGMP you're running.

 

https://router-address.com/ 

https://whatmyagenow.com/ 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers