2385
Views
0
Helpful
2
Replies
Send ipv6 prefix log to radius server
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-14-2019 07:13 PM - edited 03-01-2019 05:56 PM
Dear, I have set up a pppoe dual stack server. The same is working normally, but the ipv6 prefix logs are not being sent to the radius server. The ipv4 prefix logs are being sent normally.
Is there any specific configuration to be made on the cisco server so that these logs are sent to the radius server?
Labels:
- Labels:
-
IPv6 Configuration
2 Replies 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-14-2019 07:31 PM
Hi @joeudes20,
Maybe this link can help you:
Regards
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-15-2019 05:29 AM
Dear, thank you for your help.
In the link I checked has excellent information regarding the configuration
of radius, but my need is that the server cisco send by radius accounting
the information of prefixes ipv6 delivered to the client. These prefixes
are locally in the cisco pool. But I need that when assigning an ipv6
prefix to the client, the cisco returns with the information of which
prefix was assigned to the client to be registered.
In the link I checked has excellent information regarding the configuration
of radius, but my need is that the server cisco send by radius accounting
the information of prefixes ipv6 delivered to the client. These prefixes
are locally in the cisco pool. But I need that when assigning an ipv6
prefix to the client, the cisco returns with the information of which
prefix was assigned to the client to be registered.
