Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, Working on turning up a new circuit with Frontier. We are using C9200L-24T sw 17.03.03 with an cisco 1000BaseSX SFP. In the Cat 9200 I see the port up/up with good light levels. I see traffic sent out of the port but zero in the otherside. T...
Cisco AP CW9166I-BWLC - Catalyst 9800-40 Wireless Controller - 17.9.4a Have these setup in our corp HQ. Users moving from AP to AP drop and have to re-establish while others move area to area with no issues. Various laptop makes and models and doesn'...
Cat 9300L Reading another thread because I needed to wipe the switch. They recommended "Factory reset all" well now I have a switch with nothing butswitch:I've tried to restart to get to romon but nothing seems to affect itSystem Bootstrap, Version 1...
Current ethernet port has been in operation for months. Now it's flapping and erroring out %ETHPORT-5-SPEED: Interface Ethernet104/1/10, operational speed changed to 1 Gbps %ETHPORT-5-IF_DUPLEX: Interface Ethernet104/1/10, operational duplex mode ch...
https://tmgmatrix.cisco.com/?si=C93180LC-EX Adding servers to the N9K-C93180LC-EX. Need 10G connectivity and see SFP-10G-SR on compatibility matrix but issue is it looks like this switch only takes QSFPs? Is there an adapter required to make the SPFs...
So I followed the instructions downloaded the latest MD put in on a usb and installed from there. Now the switch looks normal until I reload. Then it goes back to Switch: Copied the IOS to flash:0 Currently did the "install add file......" and seein...
I realize this is an old thread. But the solution is not entirely correct. GLC-TE is listed as a compatible SFP and that would make the port electrical (Ethernet) Do the options appear after ethernet SFP is inserted?
According to Cisco TAC the N3K-3524P-10G-X will do 10G via fiber but not RJ-45. Even though the fiber SFP converts the laser to electrical to transit the switch. Even though there is a 10G RJ-45 SFP made by Cisco out there. What a load of donkey wa...
