02-11-2006 08:08 AM
Hi,
I am setting up EoMPLS (AToM) in my lab. Topology is simple, just have 2 Cat6509 (with native IOS) connect back-to-back. These 2 Catalyst act as PE. On each catalyst, there is one catalyst acting as host (CE). I am configuring 'mpls l2transport' under interface vlan, instead of subinterface. It is weird when i found that under subinterface, there is no command 'mpls l2transport' nor 'xconnect'. Both command is available only under interfce vlan and L3 interface.
You all can check my configuration. Thanks fr every response.
02-11-2006 08:24 AM
Change the netmask of the loopback address on R1 to /32 instead of /24.
Also "mpls ip" doesn't need to be configured on interface vlan23.
Hope this helps,
02-12-2006 07:39 AM
Hello
Please do the configuration on physical interface except over Vlan
interface GigabitEthernet1/45
mpls l2transport route 1.1.1.1 100
no ip address
end
What is superviser engine on 6500
02-12-2006 01:36 PM
Could you also attach a "show mpls l2transport vc detail" from R2.
Thanks,
02-13-2006 12:59 AM
Hi,
EoMPLS is not supported on Layer 3 VLAN interfaces for C6500/7600.
If you need to configure EoMPLS on the SVI the core-facing card must be an OSM.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/pfc3mpls.htm#wp1279824
Kind regards,
Dmitriy.
02-13-2006 07:48 AM
HI Dmitriy
EoMPLS is supported on 6500 and 7609 if you have sup7203b or sup7203bxl cards.
you need OCM base cards for VPLS
well can you attache sh tech file here...
Kind regards
Zeeshan Nadeem
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide