Dear all, I would like to ask you whether this is a valid MPLS Core design with two RRs, also should the two RRs include MPLS configuration as well? Thank you in advance for all comments and suggestions.

Hi all is there any equivalent IOS XE "no bgp default route-target filter" command on IOS XR? Regards Seek

Hello everyone,I'm trying to debug a pretty annoying issue with maintaining accurate subscriber-to-IP associations for PPPoE customers in our SCE SM database.  p3radiussniff shows lots of accounting-stop RDRs and as many failed logouts (zero successf... view more

Hi everyone,  Is there any way to control the packet loss measurement for SLM/Y1731 on ASR9k? For example, I have created a probe to send 60 packets every second, but it happens I lose one packet, therefore the packet loss would be 1/60=1.67%, w... view more

So I'm new to all this and are pretty much starting at zero.Our Customer is using an analog phone connection that gets converted to digital via a Siemens modem.After that it goes through a Cisco 2821 Router and over ethernet to 4 Cisco servers (CUCM,CUCM,... view more