cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2430
Views
25
Helpful
6
Replies

3560CX Version 15.2(4)E2 radius config issue

philipvip
Community Member

do NOT support the command below: 

radius-server host x.x.x.x auth-port 1812 acct-port 1813

how to solve?

sw(config)#radius-server ?
  accounting          Accounting information configuration
  attribute           Customize selected radius attributes
  authorization       Authorization processing information
  backoff             Retry backoff pattern(Default is retransmits with
                      constant delay)
  cache               AAA auth cache default server group
  challenge-noecho    Data echoing to screen is disabled during
                      Access-Challenge
  configure-nas       Attempt to upload static routes and IP pools at startup
  dead-criteria       Set the criteria used to decide when a radius server is
                      marked dead
  deadtime            Time to stop using a server that doesn't respond
  directed-request    Allow user to specify radius server to use with `@server'
  domain-stripping    Strip the domain from the username
  load-balance        Radius load-balancing options.
  optional-passwords  The first RADIUS request can be made without requesting a
                      password
  retransmit          Specify the number of retries to active server
  retry               Specify how the next packet is sent after timeout.
  source-ports        source ports used for sending out RADIUS requests
  throttle            Throttle requests to radius server
  timeout             Time to wait for a RADIUS server to reply
  transaction         Specify per-transaction parameters
  unique-ident        Higher order bits of Acct-Session-Id
  vsa                 Vendor specific attribute configuration

sw(config)#radius-server

1 Accepted Solution

Accepted Solutions

geder
Level 1
Level 1

Hi

You have to use the newer command radius server.

for example:

radius server ISE

  address ipv4 10.10.10.1

  key RADIUSKEY

Kind Regards

Gernot

View solution in original post

6 Replies 6

Gagandeep Singh
Cisco Employee
Cisco Employee

Hi,

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960cx_3650cx/software/release/15-2_4_e/configurationguide/b_1524e_consolidated_3560cx_2960cx_cg/b_1524e_consolidated_3560cx_2960cx_cg_chapter_0110100.html#task_1091663

seems like it is supported as per document.

Regards

Gagan

PS: rate if it helps!!!

geder
Level 1
Level 1

Hi

You have to use the newer command radius server.

for example:

radius server ISE

  address ipv4 10.10.10.1

  key RADIUSKEY

Kind Regards

Gernot

https://slaptijack.com/networking/new-style-tacacs-configuration/

Keep above link for reference.

Regards

Gagan

PS: rate if it helps!!!

new command didn't work for me either

Hi,

Have you enabled the AAA services?

 

(config)#aaa new-model

 

Thanks,
Octavian

yeah, that was it.   I figured it out last night.

dumb mistake