Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
PC#3 at WANsite#2 is sending gobs of data to PCs 1 & 2 at WANsite#1, but the router interface at WANsite#3 also sees this conversation (NetFLOW) even though it is on a completely unrelated leg of the network. I am attaching a diagram showing how the...
I need to temporarily block two IP subnets at a remote site from reaching across the WAN, but they need to talk to each other in the meantime. These subnets exist on my 4451 at Gi0/0/1.70 (10.63.70.0/24) and Gi0/0/1.71 (10.63.71.0/24), and they need...
I have this same problem, but I can't get to a command line. I have replaced the PSUs (I have two) with known good PSUs, and I still get the same results. The red LED is on for "PS OK" and the switch boots up to this point then repeats the message ...
No ERSPAN configured, and no multicast configured at any of the WANsites.It is just really strange that my NetFlow data in SolarWinds shows at least half of the GB of data in that all-day-long conversation showed in (flowed through) the outside inter...
That look great and mostly accurate from what little I know about ACLs.I just have a question about how it is applied to that interface... Should it be applied to the inbound as you have it or the outbound of the WAN interface?What if I wanted to blo...
