12-26-2007 08:50 PM - edited 03-10-2019 03:35 PM
I am trying to enable 802.1x on one of
the switchports of the Cisco Catalyst
2960:
C2960#sh run | i radius
aaa authentication login test group radius local
aaa authentication dot1x default group radius
radius-server host 10.250.97.26 auth-port 1812 acct-port 1813
radius-server source-ports 1645-1646
radius-server key 123456
C2960#sh run | i dot
aaa authentication dot1x default group radius
dot1x system-auth-control
dot1x guest-vlan supplicant
dot1x critical eapol
C2960#conf t
Enter configuration commands, one per line. End with CNTL/Z.
C2960(config)#int g0/14
C2960(config-if)#dot1x ?
% Unrecognized command
C2960(config-if)#dot1x
As you can see, I can not enable 802.1x
at the interface level. The code is am running is 12.2.25SEE4:
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 24 WS-C2960G-24TC-L 12.2(25)SEE4 C2960-LANBASEK9-M
System image file is "flash:c2960-lanbasek9-mz.122-25.SEE4.bin"
According to Cisco, this image supports
802.1x. Why can't enable it at the
interface level?
Can someone help me out? Thanks.
12-26-2007 08:53 PM
some additional info:
C2960#sh dot1x all
Sysauthcontrol Enabled
Dot1x Protocol Version 2
Critical Recovery Delay 100
Critical EAPOL Enabled
C2960#
01-01-2008 11:22 AM
Hi
Before typing dot1x under interface try
C2960(config)#int g0/14
C2960(config-if)# switchport mode access
C2960(config-if)# dot1x ?
Jon
04-24-2008 04:44 AM
This works only if switchport is access port. So configure switchport mode access.
04-24-2008 05:17 AM
You must input "swithport mode access" first, then you can input 802.1x cmd.
Regards,
~JG
Do rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide