aaa authorization commands radius and ACS 5.x
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2014 01:22 PM - edited 03-10-2019 09:44 PM
Having issues getting "aaa authorization commands radius" working in ACS 5.5 for a simple deny or permit statement. I have the Vendor VSA configured as in 4.2 but cannot get this working correctly on 5.5. Anyone have this issue or can provide insight on how to configure.
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2014 12:48 AM
Hey,
Which device are you configuring this on:
aaa authorization commands radius
?
What Command Set do you have configured on the ACS?
Rate if Useful :)
Sharing knowledge makes you Immortal.
Regards,
Ed
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2014 12:35 PM
Please provide the whole config of the device or at the minimum all of the AAA and radius configurations.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-18-2014 05:38 AM
Vendor-specific attributes (VSAs) allow vendors to create extensions to the RADIUS attributes. Vendors are assigned a specific vendor numbers. VSAs are attributes that contain subattributes. ACS 5.5 allows you to create, duplicate, and edit RADIUS VSAs.
