aaa new-model % Unrecognized command

[anishinc4u]

am trying to enable aaa new-model in cisco SG300 switch, but getting below mentioned error.

switch(config)#aaa new-model
% Unrecognized command

can anybody let me know, what am missing here.

Thanks..Anish

[marce1000]

 - For 'safety' use latest firmware version if not yet done, and verify the issue again.

 M.

[anishinc4u]

Hi

am using the latest firmware which is available now.

Software Information: 

Firmware Version (Active Image):1.4.11.4

Thanks..Anish

[Anurag Sharma]

Hi @anishinc4u 

Not sure about the CLI of this device, but it seems it has quite a nice UI to configure RADIUS, TACACS, 802.1x.

See the following KBs:

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-managed-switches/smb102-radius-configuration-on-the-200-300-series-managed-switches.html

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-300-series-managed-switches/smb5105-configuring-802-1x-on-sg300-series-switches.html

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-300-series-managed-switches/smb1470-tacacs-server-configuration-on-the-300-series-managed-switc.html

[poongarg · Accepted solution]

In the Cisco Small Business Switches does not exist the aaa new-model command. Here is the CLI guide for your reference:
https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_300.pdf

[Greg Gibbs]

You should also note that the SG300 is not listed in the ISE Network Component Compatibility list, so it has not been tested/validated against ISE.