06-10-2020 03:17 AM
Hello,
I am getting the below Auth Error:
AUTH-ERROR: [Gi1/0/24] auth_mgr_swsb missing, Unable to get int policy configured status
Interface config:
interface GigabitEthernet1/0/24
switchport access vlan 3
switchport mode access
!
Interface is connected to an Access point. Access point is working without known issues.
I have configured radius auth with windows using the below commands:
aaa new-model ! ! aaa group server radius RSERVER server-private 192.168.0.2 auth-port 1812 acct-port 1813 key 7 PASS server-private 192.168.0.3 auth-port 1812 acct-port 1813 key 7 PASS ! aaa authentication dot1x default group RSERVER dot1x system-auth-control
Any Ideas?
Thank you
06-10-2020 04:42 AM
Hi @dirar ,
Do you want to configure authentication on the port 1/0/24?
Coz, at the moment, there are no authentication commands configured. If you do 'show auth session inter Gi1/0/24 detail', what do you see?
06-10-2020 06:09 AM
Actually no, the port 24 has no authentication but I keep getting the strange error I mentioned before
06-10-2020 06:32 AM
06-10-2020 01:27 PM
Thank you for your answer. So to add in the interface:
dot1x port-control auto
or
authentication port-control auto
06-10-2020 06:46 PM
It depends upon your switch SW version.
Cisco IOS Release 12.2(46)SE and earlier- "dot1x port-control auto"
Cisco IOS Release 12.2(50)SE or later- "authentication port-control auto"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide