ACS 2.6 Reporting

[m.cartwright]

I am using ACS 2.6 NT. I am using Radius Auth and Acct. I have entries in Passed and Failed logs. I also get stop and start data in my Radius Accting log. I am unable to get any data viewing Logged-in users report. While users are actively on the PIX 6.0 I get no data. Any suggestions on settings.

Much Thanks.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

[ROBERT Clark]

I have also seen this with ACS 2.6 and NT. Did you ever find a solution?