ACS 4.2 For Windows DB Replication
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2010 02:19 PM - edited 03-10-2019 05:15 PM
Hi Folks.
I have a pair of ACS for windows 4,2 and we also have a few mappings (ACS Group --> AD Group)
The replication process was configured and it replicates all the seetings, but the Group Mappings.
Is this the way it's supposed to be or it should replicate the group mappings as well?
Best regards,
AL
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-13-2010 05:30 PM
I think it depends on what options you have selected under:
system / ACS Internal Database replication / replication components
You can set the send or receive options. One is 'user and group database' the next one is 'group database only'.
You also can't do NDGs and NAPs at the same time - has to be one or the other.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-14-2010 01:45 AM
Hi Folks.
I have a pair of ACS for windows 4,2 and we also have a few mappings (ACS Group --> AD Group)
The replication process was configured and it replicates all the seetings, but the Group Mappings.
Is this the way it's supposed to be or it should replicate the group mappings as well?
Best regards,
AL
Hi ,
Rob is right selected parameter under replication tab will replicated to secondary ACS,check under system configuration--database replciation then the following paramters are selected for replication in Primary ACS.
Hope to Help !!
Ganesh.H
Remember to rate the helpful post

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-14-2010 02:27 AM
The following items cannot be replicated:
•IP pool definitions (for more information, see About IP Pools Server).
•ACS certificate and private key files.
•Unknown user group mapping configuration.
•Dynamically-mapped users.
•Settings on the ACS Service Management page in the System Configuration section.
•RDBMS Synchronization settings.
User guide
Regards,
Jatin
Do rate helpful posts-
