06-06-2012 06:23 AM - edited 03-10-2019 07:10 PM
In acs, we are able to see the username and some other info about the user authing, but what I am unable to view is IP address, and mac address. Is it possible to have the wireless controller send over that info in radius and to be able to view it in acs?
06-06-2012 06:51 AM
Did you check the same information under
Monitoring & Reports > | Reports > | Catalog > | AAA Protocol |
While you see a log entry >> click on the magnifying glass to see all the information.
Regards,
Jatin
Do rate helpful posts-
06-06-2012 06:58 AM
In the RADIUS Authentication Detail report, MAC/IP Address is blank in the Auth Summary, and the Framed IP is blank under user.
06-06-2012 07:46 AM
So did you turn on the debugs on the controller to check if controller is sending the same information or not.
You may check this by enabling
debug aaa radius enable
do let me know.
Regards,
Jatin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: