ACS appliance 3.3 - user with mulptile static IPs

[ccarreto]

Hi,

currently we are using ACS Unix. There it os possible to assign static IPs to a user based on the radius dictonary.

e.g.

NAS1- Ascent Max uses dictionary Ascend gets 10.1.1.1

NAS2- VPN 3000 uses IETF gets 10.1.2.1

Any ideas how this could be resolved on an ACS appliance?

Regards, Celio

[mmellet]

Following installation and initial configuration, see the User Guide for Cisco Secure ACS Solution Engine Version 3.3 for information on how to use a browser and the HTML interface to fully configure your Cisco Secure ACS Solution Engine to provide the AAA services you want from this installation.

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_guide_chapter09186a0080235f77.html